CAMAC 206 Module Versions

February 6, 2008

C204 Versions
LocationCrate Slot
MP01$71 N7
ORBMP$30 N22
MP02$42 N22
HLRF$90 N2

For MP01 $71 N7 (Removed from service)

  1. Set $71 N21 C178 DCE0 to $0F
  2. Set C206 to 0011 0000, $30=48 Counts/16=3Hz
  3. Remove cable from MP01 Tawser to TEP
  4. Connect cable from Tawzer to C206
  5. Connect cable from C206 to TEP
  6. Jumper cables to bypass C206 I/O
  7. Replace Ch 6 jumper for RCCE C200 I/O
  8. B:MP01RL

For ORBMP $30 N22 (Removed from service)

  1. Set $30 N19 C178 DCE0 to $0F
  2. Set C206 to 0110 0000, $60=6Hz, Mod. $70=7Hz, Mod. $78=120Counts/16=7.5Hz
  3. Disconnect C287 cable from TEP
  4. Connect C206 cable to TEP
  5. Jumper cables to bypass C206 I/O
  6. Replace Ch 6 jumper for RCCE C200 I/O
  7. B:ORBMRL
  8. Added C064 Ver13 $30N23 to condition rate limit

For MP02 $42 N22 (Removed from service)

  1. Set $42 N21 C178 DCE0 to $0F
  2. Set C206 to 0011 0000, $30=48 Counts/16=3Hz
  3. Disconnect Tawser end of cable from MP02 Tawzer to TEP
  4. Connect cable from Tawzer to C206
  5. Jumper cable from Tawzer and to TEP to bypass C206 I/O. BNC bullet needed.
  6. Replace Ch 7 jumper for RCCW C200 I/O

For HRLF $90 N2 (Installed 7-29-04) Specially modified for HLRF only

  1. Set $92 N19 C178 DCE6 to $0F
  2. Set C206 to 0001 0000, $10=16 Counts/1.5 Sec=11Hz
  3. Changed boundry from 16sec to 1.5 sec (chip U7, see schematic)
  4. Trig input from HLRF
  5. Beam Permit output cable to C064 Version 14 ($90 N1)
  6. Trig out to C064 ($90N1)
  7. C064 Gate1 Out to RCCE C200 Inpout panel #1
  8. C064 Gated1 Out to HLRF
  9. B:HLRFRL

Security, Privacy, Legal