W115: SWIC/MW TEST

works similar to other swic programs.
See This Link

this is just an example below of how to operate the program. and should
depend on what wire or swic your working with good luck.

1. click between the yellow diamonds where it says swic. 
   select the wire you want to work with.		

2. In the calculations box click betwen the brackets the proper settings
    should come up M S I F HoRZ the last two brackets have to be typed in
    1 and 48  
     do the same for the next line m s i f vert 1 48 do not hit the yellow
    diamond or close or you will have to start over now go to the measurement
    box and hit send to send the settings. These settings are just an example


4.  the measurement box should be used to set the type of wire/swic and 
    the gain.


5. Events these have to be set properly to work the start time is the reset
   and must occur at least aprox 25ms before the sample the wire should
    sample for aprox 20ms. for example setting the RDF wire <00> <0D> <FE>
   Stop stops. 


Note the proper events have to be enabled and going out at the right times
or it wont work properly.